Car Care Products

Special active solvent for cleaning typical contamination and deposits found in the intake and throttle valve areas. Dissolves and removes all smeary deposits and contaminants such as oil, resins, adhesive residues, etc. Also reliably cleans nozzles and internal components. Ensures the operability of all moving parts and reduces fuel consumption.

Applications
To be used for all gasoline engines with  Air Intake Cleaner Tool/Equipment.

EGR CLeaner is formulated to liquefy and remove even the most stubborn oil deposits and unbumed fuel formed by EGR and PCV gases as the pass through the air intake and intake valves. EGR Cleaner will liguefy the deposits allowing them to be bured in the normal Combustion process.

Applications
For the air intake manifold, inlet valves and EGR valve of all diesel engines. Also recommended to be used at each service interval to maintain cleanliness Possibility to use an extension spray tube with multiple injection holes (option).

Engine Flush is a specially formulated combination of additives and carrier fluid. In combination with the carrier fluid, the highly effective detergent and dispersant additives dissolve sludge and lacquer formers. All types of oil-soluble and oil insoluble residues are brought into suspension and removed during the next oil change. An engine which has been cleaned of deposits and contamination and which is then filled with fresh oil not contaminated with old impurities can develop its full performance characteristics.

Applications
Cleaning and flushing out the oil circuits of gasoline and diesel engines. The use of Engine Flush is dependent on the degree of contamination of the oil circuit. Not suitable for use on motorbikes with wet clutches. One 300ml can is sufficient for up to 6 liters of oil. Add engine flush to the motor oil at running temp, before changing the oil,. After adding the product, allow the engine to idle for approx. 10 minutes. Then change the oil and the filter, Engine Flush is compatible with all commercially available motor oils.

Remove deposits on injection valves & intake valves same prevent to reforming. Improves engine running and optimizes the exhaust gas values. Eliminates start problems and rough engine running. Maintain and protect the entire fuel system from wear, deposits & corrosion.

Applications
For rectifying problems such as difficulties with starting, irregular idling, poor throttle response, performance losses, surges due to lean mixture and poor exhaust values caused by contaminated injection systems. Repeat treatment if problems reoccur. Suitable for all gasoline injection systems.

Remove deposits on injection valves & intake valves same prevent to reforming. Improves engine running and optimizes the exhaust gas values. Eliminates start problems and rough engine running. Maintain and protect the entire fuel system from wear, deposits & corrosion.

Applications
For rectifying problems such as difficulties with starting, irregular idling, poor throttle/ EGR response, performance losses, surges due to lean mixture and poor exhaust values caused by contaminated injection systems. Repeat treatment if problems reoccur. Suitable for all diesel injection systems.

A concentrate specially developed for cooling systems in general but particularly those in motor vehicles. Dissolves contaminants containing lime and oil in radiators, heating systems, pipes and in engines. Modern formula containing complex ants with active cleaning agents.

Applications: Suitable for all cooling water systems in motor vehicles, buses and commercial vehicles. Add contents to the cooling water. Run the heating system. Depending on the degree of contamination, let the engine run approximately 10 to 30 minutes. Drain the cleaner and flush out the cooling system with water. Fill the cooling system according to the manufacturer's instructions. The contents (300 ml) is sufficient for 10 liters of water.